Price Information
| Cat No. | Plasmid Name | Availability | Add to cart |
|---|---|---|---|
| V012971 | pUC35s-RAT5-a-mCherry | In stock, 1 week for quality controls |
Buy one, get one free! |
Two tubes of lyophilized plasmid will be delivered, each tube is about 5µg.
Basic Vector Information
- Vector Name:
- pUC35s-RAT5-a-mCherry
- Antibiotic Resistance:
- Ampicillin
- Length:
- 4890 bp
- Type:
- Protein expression
- Replication origin:
- ori
- Host:
- Plants
- Promoter:
- CaMV35S(long)
- Growth Strain(s):
- DH5a
- Growth Temperature:
- 37℃
pUC35s-RAT5-a-mCherry vector Map
Plasmid Protocol
1. Centrifuge at 5,000×g for 5 min.
2. Carefully open the tube and add 20 μl of sterile water to dissolve the DNA.
3. Close the tube and incubate for 10 minutes at room temperature.
4. Briefly vortex the tube and then do a quick spin to concentrate the liquid at the bottom. Speed is less than 5000×g.
5. Store the plasmid at -20 ℃.
6. The concentration of plasmid re-measurement sometimes differs from the nominal value, which may be due to the position of the lyophilized plasmid in the tube, the efficiency of the re-dissolution, the measurement bias, and adsorption on the wall of the tube, therefore, it is recommended to transform and extract the plasmid before using it
General Plasmid Transform Protocol
1. Take one 100μl of the competent cells and thaw it on ice for 10min, add 2μl of plasmid, then ice bath for 30min, then heat-shock it at 42℃ for 60s, do not stir, and then ice bath for 2min.
2. Add 900μl of LB liquid medium without antibiotics, and incubate at 37℃ for 45min (30℃ for 1-1.5 hours) with 180rpm shaking.
3. Centrifuge at 6000rpm for 5min, leave only 100μl of supernatant to resuspend the bacterial precipitate and spread it onto the target plasmid-resistant LB plate.
4. Invert the plate and incubate at 37℃ for 14h, or at 30℃ for 20h.
5. Pick a single colony into LB liquid medium, add the corresponding antibiotics, incubate at 220rpm for 14h, and extract the plasmid according to the experimental needs and the instructions of the plasmid extraction kit.
pUC35s-RAT5-a-mCherry vector Sequence
LOCUS V012971 4890 bp DNA circular SYN 01-JAN-1980
DEFINITION Exported.
ACCESSION V012971
VERSION V012971
KEYWORDS .
SOURCE synthetic DNA construct
ORGANISM synthetic DNA construct
.
REFERENCE 1 (bases 1 to 4890)
AUTHORS .
TITLE Direct Submission
FEATURES Location/Qualifiers
source 1..4890
/mol_type="other DNA"
/organism="synthetic DNA construct"
primer_bind 1..17
/label="M13 rev"
/note="common sequencing primer, one of multiple similar
variants"
promoter 541..886
/label="CaMV 35S promoter"
/note="strong constitutive promoter from cauliflower mosaic
virus"
CDS 901..1290
/gene="RAT5"
/label="Histone H2A.6"
/note="Histone H2A.6 from Arabidopsis thaliana. Accession#:
Q9LD28"
CDS 1303..2010
/label="mCherry"
/note="monomeric derivative of DsRed fluorescent protein
(Shaner et al., 2004)"
terminator 2030..2282
/label="NOS terminator"
/note="nopaline synthase terminator and poly(A) signal"
primer_bind complement(2291..2307)
/label="M13 fwd"
/note="common sequencing primer, one of multiple similar
variants"
promoter 2781..2885
/label="AmpR promoter"
CDS 2886..3743
/label="AmpR"
/note="beta-lactamase"
rep_origin 3917..4505
/label="ori"
/note="high-copy-number ColE1/pMB1/pBR322/pUC origin of
replication"
protein_bind 4793..4814
/label="CAP binding site"
/note="CAP binding activates transcription in the presence
of cAMP."
promoter 4829..4859
/label="lac promoter"
/note="promoter for the E. coli lac operon"
protein_bind 4867..4883
/label="lac operator"
/note="The lac repressor binds to the lac operator to
inhibit transcription in E. coli. This inhibition can be
relieved by adding lactose or
isopropyl-beta-D-thiogalactopyranoside (IPTG)."