pLV3-U6-MCS-shRNA-Fluc-Blast vector (V014849)

Price Information

Cat No. Plasmid Name Availability Add to cart
V014849 pLV3-U6-MCS-shRNA-Fluc-Blast In stock, 1 week for quality controls

Buy one, get one free!

Two tubes of lyophilized plasmid will be delivered, each tube is about 5µg.

Basic Vector Information

Vector Name:
pLV3-U6-MCS-shRNA-Fluc-Blast
Antibiotic Resistance:
Ampicillin
Length:
8970 bp
Type:
RNA interference
Replication origin:
ori
Host:
Mammalian cells, Lentivirus
Selection Marker:
Blast
Promoter:
hPGK
5' Primer:
U6-F:GAGGGCCTATTTCCCATGA
Growth Temperature:
37℃

pLV3-U6-MCS-shRNA-Fluc-Blast vector Map

pLV3-U6-MCS-shRNA-Fluc-Blast8970 bp40080012001600200024002800320036004000440048005200560060006400680072007600800084008800hPGK promoterBSD3' LTR (Delta-U3)SV40 poly(A) signalSV40 oriT7 promoterM13 fwdf1 oriAmpR promoterAmpRoriCAP binding sitelac promoterlac operatorM13 revT3 promoterRSV promoter5' LTR (truncated)HIV-1 PsiRREgp41 peptideProtein TatU6 promoterCMV enhancerCMV promoterluciferasecPPT/CTShPGK promoter

Plasmid Protocol

1. Centrifuge at 5,000×g for 5 min.

2. Carefully open the tube and add 20 μl of sterile water to dissolve the DNA.

3. Close the tube and incubate for 10 minutes at room temperature.

4. Briefly vortex the tube and then do a quick spin to concentrate the liquid at the bottom. Speed is less than 5000×g.

5. Store the plasmid at -20 ℃.

6. The concentration of plasmid re-measurement sometimes differs from the nominal value, which may be due to the position of the lyophilized plasmid in the tube, the efficiency of the re-dissolution, the measurement bias, and adsorption on the wall of the tube, therefore, it is recommended to transform and extract the plasmid before using it

General Plasmid Transform Protocol

1. Take one 100μl of the competent cells and thaw it on ice for 10min, add 2μl of plasmid, then ice bath for 30min, then heat-shock it at 42℃ for 60s, do not stir, and then ice bath for 2min.

2. Add 900μl of LB liquid medium without antibiotics, and incubate at 37℃ for 45min (30℃ for 1-1.5 hours) with 180rpm shaking.

3. Centrifuge at 6000rpm for 5min, leave only 100μl of supernatant to resuspend the bacterial precipitate and spread it onto the target plasmid-resistant LB plate.

4. Invert the plate and incubate at 37℃ for 14h, or at 30℃ for 20h.

5. Pick a single colony into LB liquid medium, add the corresponding antibiotics, incubate at 220rpm for 14h, and extract the plasmid according to the experimental needs and the instructions of the plasmid extraction kit.

pLV3-U6-MCS-shRNA-Fluc-Blast vector Sequence

LOCUS       V014849                 8970 bp    DNA     circular SYN 01-JAN-1980
DEFINITION  Exported.
ACCESSION   V014849
VERSION     V014849
KEYWORDS    .
SOURCE      synthetic DNA construct
  ORGANISM  synthetic DNA construct
            .
REFERENCE   1  (bases 1 to 8970)
  AUTHORS   .
  TITLE     Direct Submission
FEATURES             Location/Qualifiers
     source          1..8970
                     /mol_type="other DNA"
                     /organism="synthetic DNA construct"
     promoter        7..507
                     /label="hPGK promoter"
                     /note="human phosphoglycerate kinase 1 promoter"
     CDS             522..917
                     /label="BSD"
                     /note="blasticidin S deaminase"
     LTR             992..1225
                     /label="3' LTR (Delta-U3)"
                     /note="self-inactivating 3' long terminal repeat (LTR) from
                     HIV-1"
     polyA_signal    1297..1431
                     /label="SV40 poly(A) signal"
                     /note="SV40 polyadenylation signal"
     rep_origin      1458..1593
                     /label="SV40 ori"
                     /note="SV40 origin of replication"
     promoter        complement(1614..1632)
                     /label="T7 promoter"
                     /note="promoter for bacteriophage T7 RNA polymerase"
     primer_bind     complement(1642..1658)
                     /label="M13 fwd"
                     /note="common sequencing primer, one of multiple similar
                     variants"
     rep_origin      1800..2255
                     /label="f1 ori"
                     /note="f1 bacteriophage origin of replication; arrow
                     indicates direction of (+) strand synthesis"
     promoter        2281..2385
                     /label="AmpR promoter"
     CDS             2386..3243
                     /label="AmpR"
                     /note="beta-lactamase"
     rep_origin      3417..4005
                     /label="ori"
                     /note="high-copy-number ColE1/pMB1/pBR322/pUC origin of
                     replication"
     protein_bind    4293..4314
                     /label="CAP binding site"
                     /note="CAP binding activates transcription in the presence
                     of cAMP."
     promoter        4329..4359
                     /label="lac promoter"
                     /note="promoter for the E. coli lac operon"
     protein_bind    4367..4383
                     /label="lac operator"
                     /note="The lac repressor binds to the lac operator to
                     inhibit transcription in E. coli. This inhibition can be
                     relieved by adding lactose or
                     isopropyl-beta-D-thiogalactopyranoside (IPTG)."
     primer_bind     4391..4407
                     /label="M13 rev"
                     /note="common sequencing primer, one of multiple similar
                     variants"
     promoter        4428..4446
                     /label="T3 promoter"
                     /note="promoter for bacteriophage T3 RNA polymerase"
     promoter        4474..4700
                     /label="RSV promoter"
                     /note="Rous sarcoma virus enhancer/promoter"
     LTR             4701..4881
                     /label="5' LTR (truncated)"
                     /note="truncated 5' long terminal repeat (LTR) from HIV-1"
     misc_feature    4928..5053
                     /label="HIV-1 Psi"
                     /note="packaging signal of human immunodeficiency virus
                     type 1"
     misc_feature    5546..5779
                     /label="RRE"
                     /note="The Rev response element (RRE) of HIV-1 allows for
                     Rev-dependent mRNA export from the nucleus to the
                     cytoplasm."
     CDS             5964..6008
                     /label="gp41 peptide"
                     /note="antigenic peptide corresponding to amino acids 655
                     to 669 of the HIV envelope protein gp41 (Lutje Hulsik et
                     al., 2013)"
     CDS             6157..6198
                     /note="Protein Tat from Human immunodeficiency virus type 1
                     group M subtype B (isolate WMJ22). Accession#: P12509"
                     /label="Protein Tat"
     promoter        6306..6546
                     /label="U6 promoter"
                     /note="RNA polymerase III promoter for human U6 snRNA"
     enhancer        6568..6871
                     /label="CMV enhancer"
                     /note="human cytomegalovirus immediate early enhancer"
     promoter        6872..7075
                     /label="CMV promoter"
                     /note="human cytomegalovirus (CMV) immediate early
                     promoter"
     CDS             7110..8759
                     /label="luciferase"
                     /note="firefly luciferase"
     misc_feature    8801..8918
                     /label="cPPT/CTS"
                     /note="central polypurine tract and central termination
                     sequence of HIV-1"
     promoter        8967..8970
                     /label="hPGK promoter"
                     /note="human phosphoglycerate kinase 1 promoter"